|
|

Open the air cleaner housing (which typically snaps together) and loosen the clamp fastening the air filter to the air inlet duct.
|

This filter has seen 20,000 miles of use in L.A., a fairly clean environment, but notice the dark buildup of grime on the element.
|

Spray the cotton-gauze filter element with the cleaning detergent. Clear the big pebbles and bugs from between the pleats with a flat-bladed screwdriver.
|

Let the air cleaner element soak in the cleaning solution for 15-20 minutes. Because you cannot scrub the element without destroying it, you just have to let the solution do the work.
|

Rinse the cleaning solution and dirt away with a garden hose. DO NOT use any pressure, as it will damage the cotton-gauze element. Just rinse from inside the filter to the outside to keep from driving the dirt farther into the filter.
|

After allowing the filter to air dry (DO NOT BLOW-DRY WITH HIGH-PRESSURE AIR), flow a line of filter oil onto each pleat. Allow time for the oil to wick into the filter for complete coverage. If you spot any areas without oil, just add a few drops in that area.
|

Most air cleaner housings collect a bunch of dirt that was repelled by the air filter. Just vacuum out the housing and you're ready to reinstall the newly serviced filter.
|

Reconnect the air filter element to the inlet tube and firmly tighten the clamp. Put the lid back on the air cleaner housing and write down the date and mileage when you did the service.
|