Clutch Replacement

Think of the clutch as a switch between your engine and the transmission. Every time you press on the clutch pedal, you turn the switch off, and no engine power gets to the transmission. Light goes off. When you let the pedal back out, the switch turns back on and away you go. Light goes on. If you let the clutch pedal halfway out, the clutch transmits roughly half the engine power to the transmission and acts more like a dimmer switch.


The clutch is able to perform this on-and-off delivery act by way of four major component parts—the flywheel, the clutch disc, the pressure plate, and the throw-out or release bearing. Since the average clutch is engaged and disengaged thousands of times over its service life all these parts will eventually wear out. Oddly enough that's what they are designed to do.

Caught in Between
The clutch disc takes most of the abuse over the service life of a clutch assembly. The clutch disc is one of those parts designed from the start to wear out as it does its job. Like a brake pad, the clutch disc wears out a tiny bit each time it is engaged. The clutch disc lies in wait and endures extreme pressure as it is sandwiched between the two steel surfaces of the flywheel and pressure plates. The material of the clutch disc absorbs friction and allows for the smooth transition of engine power to the transmission from the flywheel through the pressure plate. Dampening springs in the center hub of the disc absorb vibration from engagement to prevent damage to the drivetrain and transmission. Eventually the clutch disc material will wear too thin and the clutch assembly will no longer be able to hold the torque, or twist, created by the engine and will slip. The heat created by this extra slipping will quickly make things worse, and soon the switch will be off for good. Light goes off. Vehicle goes nowhere.

Unit, Not Parts
While the clutch disc is usually the part that wears out first, all components should be inspected or replaced when servicing the clutch. The flywheel should always be resurfaced for chatter and vibration-free engagement. Pressure plates should be replaced if worn. The throw-out or release bearing can also raise a ruckus and start howling as it wears out. Since this bearing handles the load of disengaging the clutch and allowing the assembly to spin freely while disengaged, replacement is usually a safe bet. The pilot bearing should also be inspected as it centers the transmission input shaft in the flywheel and allows it to spin. For these reasons, it is a smart strategy to replace the entire clutch assembly as a unit. Readily available kits, complete with alignment tool, are a great way to get everything required for the job in one box.

Opening the Can
The clutch is one of those parts, like a cylinder head gasket, or a timing belt, that while not prohibitively expensive by itself, can be a real chore to access. On a rear-drive vehicle, getting down to the clutch requires removal of the driveshaft and transmission. On a front-wheel-drive vehicle, the task becomes more complex. And on an all-wheel-drive vehicle, a true maze of components must be removed to get down to the clutch assembly. While replacing the clutch assembly itself usually takes a matter of minutes, getting the transmission and everything else out of the way, and then put back in again can take many hours.